Eclipse Combustion F8000 Series Service/ Instruções de Operação descarregar pdf (Página 26)

2-12

5. STOW LOCK SETTING

The proper stow lock setting is determined by the position of the carriage assembly safety

blocks relative to the position of the carriage stop blocks attached to the enclosure assembly

at the rear of the lift. Refer to Figure [2-10]. Setting the stow lock mechanism requires the

adjustment of two (2) carriage stop block set screws so that the stow lock hook is properly

engaged by the stow lock striker plate.

FIGURE [2-10]: STOW LOCK HOOK ADJUSTMENT

a. Stow the lift completely inside the lift enclosure. The spring-loaded stow lock handle

located on the left-side of the enclosure assembly must be in its "down" position, with the

stow lock hook engaged by the stow lock striker plate.

b. Determine how much adjustment is required. The distance between the deploy lock hook

and striker plate should be no more than 1/16". If the distance is out of tolerance or the

stow lock mechanism does not engage properly, proceed with this adjustment procedure.

c. Make sure lift is fully stowed.

d. From the rear of the lift, remove plugs from rear channel left/right carriage stop blocks

access holes.

e. With an allen wrench, turn the stop block set screws clockwise to decrease the gap

distance, or counter-clockwise to increase the gap distance. One (1) full turn is equivalent

to 1/16" of adjustment. Be sure to adjust set screws simultaneously an equal number of

turns.

f. Repeat check procedure as described above and adjust set screws as required until the

proper gap distance is achieved. Deploy and stow the lift several times to ensure proper

operation of the stow lock mechanism.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 76 77

Sem comentários

Eclipse Combustion F8000 Series Service/ Instruções de Operação Página 26